Disabling Internal Switch Port for OSN
You can enable or disable the Ethernet port of the device's internal switch, which interfaces with the OSN server. If the port is not blocked, you can optionally access the OSN server through any Ethernet port on the device's front panel (instead of through the OSN module's Ethernet ports located on the rear panel). If you block the port, then you can access the OSN server only through the Ethernet ports on the OSN module.
You can also view the status of the port (Up or Down), by running the following CLI command:
# show network interface osn
|
➢
|
To enable / disable the internal switch's Ethernet port interfacing with OSN: |
|
1.
|
Open the Network Settings page (Setup menu > IP Network tab > Advanced folder > Network Settings). |
|
2.
|
From the 'Block OSN Port' drop-down list, select Enable or Disable: |
